Epson SureLab D870 Manual

Epson SureLab
®
Start Here
IMPORTANT: Before using this product, make sure you read these instructions
and the safety instructions in the online Operation Guide.
Choose a location for the printer
Choose a location for the printer that is near a wall outlet where the power cord
can be easily unplugged. Avoid places subject to rapid changes in temperature
and humidity. Also keep the printer away from direct sunlight, strong light, or
heat sources.
Make sure to place the printer on a flat, stable surface with enough space on
all sides.
13.9 in.
(354 mm)
1.2 in.
(30 mm)
16.9 in.
(430 mm)
1.2 in.
(30 mm)
Unpack
1
Make sure you have these items:
Printer
Note: Ink cartridges are not included.
2
Remove all of the packaging materials and tape from the outside of the
printer.
3
Remove the scrap paper box.
4
Remove all the packaging materials and tape from inside the roll paper
feeder.
D870
®
1.2 in.
(30 mm)
18.1 in. 11.8 in.
(460 mm) (300 mm)
Limited
warranty
Power cord
5
Grip the handle to release the roll paper feeder and pull it out.
6
Remove the spindle and set it aside.
7
Push the roll paper feeder back into the printer.
8
Reattach the scrap paper box.
9
Open the ink cartridge covers and remove the packaging materials and
tape from inside the printer.
Install ink cartridges
1
Remove the ink cartridges from their packages.
Caution: Do not touch the green chip on top of the cartridge.
2
Insert each cartridge into the correct slot for its color.