Important Safety Instructions For Battery Chargers - Black & Decker LHT2220 Instruction Manual

20v cordless hedge trimmer
Hide thumbs Also See for LHT2220:
Table of Contents

Advertisement

Available languages

Available languages

24 • ENGLISH
to a complete standstill.
f Regularly check the blades for damage and wear. Do
not use the tool when the blades are worn or
damaged.
f Take care to avoid hard objects (e.g. metal wire,
railings) when trimming. Should you accidentally hit
any such object, immediately switch the tool off,
unplug it and check for any damage.
f Should the tool start to vibrate abnormally,
immediately switch it off and check for any damage.
f If the tool stalls, immediately switch it off. Unplug the
tool before attempting to remove any obstructions.
f After use, place the blade sheath supplied over the
blades.
f Store the tool, making sure that the blade is not
exposed.
f Always ensure that all handles and guards are fitted
when using the tool. Never attempt to use an
incomplete tool or a tool with unauthorized
modifications.
f Never allow children to use the tool.
f Be aware of falling debris when cutting the higher
sides of a hedge.
f This appliance is not intended for use by young or
infirm persons without supervision. Children must be
supervised to ensure they do not play with the
appliance.
f If the supply cord is damaged, it must be replaced by
the manufacturer or an authorized BLACK+DECKER
Service Centre in order to avoid a hazard.
IMPORTANT SAFETY INSTRUCTIONS
FOR BATTERY CHARGERS
Save these instructions: This manual contains important
safety instructions for battery chargers.
f Before using charger, read all instructions and
cautionary markings on charger, battery pack, and
product using battery pack.
Warnings! Shock hazard. Do not allow any liquid to
get inside charger.
Caution: Burn hazard. To reduce the risk of injury, charge
only designated BLACK+DECKER batteries. Other types of
batteries may burst causing personal injury and damage.
Caution: Under certain conditions, with the charger
plugged in to the power supply, the charger can be shorted
by foreign material. Foreign materials of a conductive
nature such as, but not limited to, steel wool, aluminum foil,
or any buildup of metallic particles should be kept away
from charger cavities. Always unplug the charger from the
power supply when there is no battery pack in the cavity.
Unplug charger before attempting to clean.
Warnings!:
f Do not attempt to charge the battery pack with
any chargers other than the ones in this manual.
The charger and battery pack are specifically designed
to work together.
f These chargers are not intended for any uses
other than charging designated BLACK+DECKER
rechargeable batteries. Any other uses may result in
risk of fire, electric shock or electrocution.
f Do not expose charger to rain or snow.
f Pull by plug rather than cord when disconnecting
charger. This will reduce risk of damage to electric
plug and cord.
f Make sure that cord is located so that it will not be
stepped on, tripped over, or otherwise subjected
to damage or stress.
f Do not use an extension cord unless it is absolutely
necessary. Use of improper extension cord could
result in risk of fire, electric shock, or electrocution.
f An extension cord must have adequate wire size
(AWG or American Wire Gauge) for safety. The
smaller the gauge number of the wire, the greater
the capacity of the cable, that is 16 gauge has more
capacity than 18 gauge. When using more than one
extension to make up the total length, be sure each
individual extension contains at least the minimum
wire size.
Voltage
Total length of cord in meters (m)
(Volts)
120-127V
0-7
220V
0-15
Rated
Minimal cross-sectional area of the
Ampere
Range
0-6A
1,0
6-10A
1,0
10-12A
1,5
12-16A
2,5
f Do not place any object on top of charger or place
the charger on a soft surface that might block the
ventilation slots and result in excessive internal
heat. Place the charger in a position away from
any heat source. The charger is ventilated through
slots in the top and the bottom of the housing.
f Do not mount charger on wall or permanently affix
charger to any surface. The charger is intended to
use on a flat, stable surface (i.e., table top, bench top).
f Do not operate charger with damaged cord or
plug — have them replaced immediately.
f Do not operate charger if it has received a sharp
blow, been dropped, or otherwise damaged in any
7-15
15-30
15-30
30-60
cord in milimeters (mm
)
2
1,5
1,5
1,5
2,5
1,5
2,5
4,0
Not recommended
30-50
60-100
2,5
4,0
4,0

Advertisement

Table of Contents
loading

Table of Contents