MULTIQUIP DS Series Parts And Operation Manual page 14

6. Place the front of the power unit over the blade (Figure 3)
until the front of the clamp is seated within the front blade
collar.
7. Ease the power unit back to allow the rear clamp to seat
itself within the rear blade collar. It may be necessary to
further loosen the wing nuts to allow the clamp to fit around
the blade collar.
8. Securely hand tighten each of the three wing nuts. The
wing nuts are spring loaded to prevent them from coming
loose during operation.
PAGE 14 — DS-SERIES DUOSCREED — PARTS & OPERATION MANUAL — REV. #1 (03/06/01)
DS-SERIES DUOSCREED — ASSEMBLY INSTRUCTIONS
Figure 4. Blade Mounting Diagram
l
Figure 5. Handle Bar Adjustment Knob
9. Two handle bar adjustment knobs (Figure 5) are located at
the base of the steering handle bar. Loosen these two knobs
to adjust the height of the steering handle bar to a suitable
working position.
10. The DuoScreed is now ready for operational use.