LG HT906TAW Owner's Manual page 16

16 Connecting
About Ferrite Core (for EMI only)
Be sure to attach the ferrite core to the speaker
cable (for connecting to this unit and wireless
receiver). This ferrite core can reduce noises.
How to attach the ferrite core
1. Press the stopper [a] of the ferrite core to open.
2. Wind the speaker cables once on the ferrite
core.
2
3. Close the ferrite core until it clicks.
Refer to the fig.3 and comment.
1
2
Rear of wierless receiver
3
(fig. 3)
HT906TAW-PM_DJORMLK_ENG_4778.indd 16
The length
here is as short
as possible.
, ,
Note
y If there is a strong electromagnetic wave
product nearby, interference may occur. Put
the unit (Wireless Receiver and main unit)
away from there.
y If there is no audio signal for longer than
10 minutes, the Wireless Receiver will
automatically switch to standby mode. In
power saving mode, both LEDs will turn red.
LEDs will turn blue when there is any audio
signal back.
y If you operate main unit then wireless
speakers (rear speakers) sound within a few
seconds in standby mode.
y Set the distance between this unit and
Wireless Receiver within 10 m (32 ft.).
y Optimum performance can be
implemented only when the Wireless
Transmitter and the Wireless Receiver within
distance of 2 m (6 ft.) to 10 m (32 ft.) is used
since communication failure may occur if
longer distance is used.
y Be sure to match the speaker cable to the
appropriate terminal on the components:
+ to + and – to –. If the cables are reversed,
the sound will be distorted and will lack
bass.
y It takes a few seconds (and may take longer)
for the Wireless Transmitter and Wireless
Receiver to communicate with each other.
y Use the rear speaker at least 30 cm (11 inch)
away from either TV screen or PC monitor.
2011-03-03 4:24:43