Fireplace Installation; Site Selection - Dimplex BLF5051-INT Owner's Manual

Fireplace Installation

Site Selection

Review and consider all of the
following conditions for installation:
• Dimensions of the unit: 128cm
x 49.5cm
• Unit requires a minimum of two
(2) wall studs in order to ensure
a secure installation
Three possible installation methods:
• Installation method: Surface
mount; In-wall Recessed; or
Flush mount
WARNING: Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord
is stored or secured to avoid
tripping or snagging to reduce
the risk of fire, electric shock or
injury to persons.
Construction and electrical
outlet wiring must comply with
local building codes and other
applicable regulations to reduce
the risk of fire, electric shock
and injury to persons.
1. Select a location that is not
susceptible to moisture and
is away from drapes, furniture
and high traffic.
2. For ease of electrical hook up
you may wish to locate the
fireplace near an existing outlet
(for plug-in convenience).
!
NOTE 1: A 13 Amp, 230 Volt
circuit is required. A dedicated
circuit is preferred but not
e s s e n t i a l i n a l l c a s e s . A
dedicated circuit will be required
if, after installation, the circuit
breaker trips or fuse blows
on a regular basis when the
heater is operating. Additional
appliances on the same circuit
may exceed the current rating
of the circuit breaker.
3. Remove
glass and hardware from box
and remove all packaging
materials before installation.
4. Store the fireplace in a safe,
dry and dust free location until
you are ready to install the
fireplace.
5. Means for disconnection must
be incorporated in the fixed
wiring in accordance with
wiring rules.
fireplace, front