Toyota RAV4 2000 Owner's Manual page 110

Sound balance adjustment function
This knob is also used to adjust the
sound balance between the front and rear,
and the right and left speakers.
For front/rear adjustment, push "AUDIO
CONTROL / MODE" repeatedly until "FAd"
appears on the display. Then turn the
knob to adjust the front/rear balance.
The display will show the range from "FAd
F7" to "FAd R7".
For left/right adjustment, push "AUDIO
CONTROL / MODE" repeatedly until "BAL"
appears on the display. Then turn the
knob to adjust the left/right balance.
The display will show the range from "BAL
L7" to "BAL R7".
CD (Compact Disc)
Push "CD" to switch from radio or cas-
sette operation to compact disc operation.
If the audio system is off, you can turn
on the compact disc player by pushing
"CD". In both cases, a disc must already
be loaded in the player.
When the audio is set into compact disc
operation, the display shows the track or,
track and disc number currently being
played. Each time you push "CD", the
system changes between single disc play-
er and automatic changer.
100
If the player malfunctions, your audio sys-
tem will display one of the following six
error messages.
If "WAIT" appears on the display, it indi-
cates that the inside of the player unit
may be too hot due to the very high ambi-
ent temperature. Remove the disc or mag-
azine from the player and allow the player
to cool down.
If "Err 1" appears on the display, it
indicates the disc is dirty, damaged, or it
was inserted up−side down. Clean the
disc or insert it correctly.
If "Err 2" appears on the display, it
indicates no disc is loaded inside the
magazine, insert a disc.
If "Err 3" or "Err 4" on the display, it
indicates there is a trouble inside the sys-
tem. Eject the disc or magazine. Set the
disc or magazine again.
If "OPEn" appears on the display, it
indicates the compact disc auto changer
lid is open. Close the compact disc auto
changer lid.
If the malfunction is not rectified, take
your vehicle to your EV service station.
∨∧
DISC
Compact disc auto changer only
By using this button, you can select a
disc you wish to listen to.
Push either side of the button several
times until the number of the disc you
want to listen to appears on the display.
∗
Dolbyr B NR
If you are listening to a tape that was
recorded with Dolbyr B Noise Reduction,
push the button marked with the double−D
symbol. The double−D symbol will appear
on the display. Push the button again to
turn off Dolbyr B NR.
The Dolby NR mode reduces tape noise
by about 10 dB. For best sound reproduc-
tion, play your tapes with this button on
or off according to the mode used for
recording the tape.
∗
: Dolby noise reduction manufactured under license
from Dolby Laboratories Licensing Corporation. "DOLBY"
and the double D symbol are trademarks of Dolby
Laboratories Licensing Corporation.
FM
Push "FM" to select the FM band. "FM1"
or "FM2" will appear on the display. This
system allows you to set twelve FM sta-
tions, two for each button.