Table of Contents
Advertisement
Installation Instructions - Single Integrated Installation
STEP 6 INSERTING/SECURING
INTO CABINET SURROUND
As you walk the unit back into the opening, you
should pull the string tight to make sure the power
cord is routed underneath the unit.
Replace the
Strain Relief
waterline strain
Screw
relief screw.
Store the
excess string
and water
tubing under the unit.
WARNING
Electrical Shock Hazard.
Replace waterline strain relief in front rail location as
shown.
AVERTISSEMENT
d'électrocution.
Reposez la vis de décharge de
tension dans le profilé avant comme illustré.
ADVERTENCIA
Eléctrica
Reemplace el amortiguador de refuerzo de
la tubería de agua frente a la ubicación del riel, como se
muestra.
STEP 7 LEVEL UNIT
All models have 4-point leveling. The front is supported
by leveling legs; the rear is supported by adjustable
wheels. Both are accessible from the front of the unit.
To level the back of the unit, turn the 7/16" hex nut
located above the front leveling legs. Turn clockwise
to raise or counterclockwise to lower the unit.
leveling leg or a 7/16" open-end wrench at the bottom
of the leveling leg.
opening 84". The unit should be level and plumb with
cabinetry.
7/16" hex nut
adjusts rear
wheels
T30 bit
adjusts front
leveling legs
Risque
Riesgo de Descarga
7/16" open end wrench
adjusts front leveling legs
STEP 7 LEVEL UNIT
NOTICE: The rear leveling wheels and front leveling
legs are limited to a maximum height adjustment of 1".
If the installation requires more than 84" height, the
installer should elevate the unit on a sheet of plywood
or runners. Cabinetry trim could also be added across
the top of the opening to shorten the opening. If you
attempt to raise the unit more than 1", you will damage
the front leveling legs and the rear leveling wheels.
STEP 8 FINAL EXTERNAL UNIT
PREPARATION
FOR FLUSH INSTALLATION:
of the door is 7/8" behind front face of surrounding
cabinets BEFORE securing brackets to the surrounding
cabinetry.
Open the doors to
the units. Locate
removal tool.
Filter should be as
shown.
counterclockwise (use
needed).
remove. NOTE: Water
54
Make sure front surface
Compartment Door
Filter
Mounting
Hook
Filter Removal Tool
31-1000600 Rev. 0
Advertisement
Table of Contents
