To connect an optical drive
Procedures for connecting an optical drive may vary, depending on the specific drive you purchase. See the manual supplied
with your optical drive for more information on its installation and use.
You can connect an optical drive while the computer is on. For specific instructions on using your supplied Application,
Driver, and System Recovery CDs, see
1.
Remove the PC Card slot protector from the PC Card slot. See
2.
Remove the PC Card from the bottom side of the optical drive.
Rem ov ing PC Card
3.
Insert the PC Card into the PC Card slot with the SONY logo facing up. See
Inserting PC Card
A protective cover is attached to the lens of the optical drive at the factory. Before using the optical drive, remove the
protective cover.
Using the Recovery CDs
for more information.
To remove a PC Card
Using PC Cards
for more information.
for details.
Page 59