Using The Oontz Remote Control - Cambridge SoundWorks Oontz Angle 3 PRO Soundbar User Manual

Using the OontZ Remote with the OontZ Angle 3 Pro Soundbar
(The OontZ app can also be used to control the OontZ Angle 3 Pro Soundbar, refer to Page 20)
To use the OontZ Remote first remove the insulation strip on the back side of the OontZ Remote as shown.
Once the insulation strip is remove, the OontZ Remote must be paired with the OontZ Angle 3 Pro Soundbar.
– Plug in the OontZ Angle 3 Pro Soundbar (Do not turn on), the Power Light should be lit Red.
– Press and hold the Play/Pause Button
- The Power Button Light on the OontZ Angle 3 Pro Soundbar will flash indicating the OontZ Angle 3 Pro Soundbar
is ready to pair with the Remote.
- Hold the remote within 3 feet (1 meter) of the OontZ Angle 3 Pro Soundbar.
– At the same time Press and hold the Bluetooth Button
– Once the remote has connected with the OontZ Angle 3 Pro Soundbar the Source Button Light will flash Green 6 times.
Note: To verify if your remote is paired with the OontZ Angle 3 Pro Soundbar press and hold the Bluetooth Button
Power Button on the remote for more than two seconds at any time when the OontZ Angle 3 Pro Soundbar is powered on.
The Source Button Light on the OontZ Angle 3 Pro Soundbar will flash 6 times when the remote and the OontZ Angle 3 Pro Soundbar
are paired.
for more than two seconds on the OontZ Angle 3 Pro Soundbar.
and the Power Button on the remote for more than two seconds.
and the
Page 10