Table of Contents
Advertisement
CHAPTER 2 STANDARDS AND ADJUSTMENTS
2. Routing the Blank Shutter Cable
Wind 3.5 times.
3. Positioning the Solenoid for the Primary Charging Roller
Loosen the two screws used to fix the solenoid
the direction of B so that the
against a of the solenoid support plate
Caution:
Be sure to make the adjustment whenever you have replaced the solenoid.
3
2-18
Attach the spring to
the outside of the
sides shutter.
Slide shutter (rear)
Figure 2-24
in Figure 2-25 is 5.5 ±0.2 mm when the joint
.
2
Figure 2-25
Slide shutter
(front)
in place, and move the solenoid in
a
= 5.5 ± 0.2
is butted
1
Advertisement
Table of Contents
