Philips 8000 Series Important Information Manual page 14

English
14
Problem
Too much water flows out
of the water tank at a too
high speed.
The floor dries with stripes
when I use the water tank.
Possible cause
The microfiber mopping pad
is not placed correctly and
blocks the wetting strip as a
result. This prevents water
from flowing out of the
wetting strip.
The water tank is empty or
nearly empty.
You are using a microfiber
mopping pad that is not
supplied by Philips.
If too much water flows out
of the water tank at a too
high speed, the cap of the
tank is probably not closed
properly.
The strip is not placed
properly in the bottom of the
water tank.
You pushed the Aqua Boost
pedal too often.
You added too much liquid
cleaner to the water.
Solution
Make sure that you place the mopping
pad correctly. Check the user manual for
proper placement.
Refill the water tank.
Only use an original Philips microfiber
mopping pad. You can buy these
mopping pads in the online Philips shop
at www.shop.philips.com/service or at
your Philips dealer.
Check the cap and make sure it is fully
and properly closed.
Check the strip and make sure that it is
fitted properly in the bottom plate of the
water tank.
Push the Aqua Boost pedal (Fig. 4) only
once each time and check after each
time if you have achieved the wetness
level you want.
Use only a few drops of liquid cleaner or
use a cleaner that foams less.