Assembly
1
Attaching the side handle
□ Attach the side handle ) to the cabinet using four bolts
(BB).
□
Tighten all bolts with the 10 mm wrench (EE).
Do not over tighten the bolts to avoid damage to the finish.
NOTE: The holes in the cabinet are tapped and do not
require nuts.
3
Installing the cord brackets
NOTE: The holes in the cabinet are tapped and do not
require nuts.
□ Attach the cord bracket
(AA) per bracket.
□ Tighten all bolts securely.
(F
□
BB
F
EE
□
(D
) to the cabinet using two bolts
D
2
Installing the casters
WARNING: Two or more people may be required for this
step due to the weight of the workbench.
CAUTION: Do not over tighten the screws.
NOTE: The holes for casters are tapped and do not require
□
Ensure all cabinet drawers are securely locked into
place
using the key (K) and lock (O) on the rolling cabinet (B .
□ Lay the rolling cabinet (B) on its back
packaging material to protect the finish.
□ Mount the four swivel casters with brake (G) to the rolling
cabinet (B) using four bolts (DD) and washers (CC) per
caster. The s wivel casters with brake (G) should be
installed on each end at the cabinet.
□ Mount the two swivel casters (I) to the center of the rolling
cabinet (B) using four bolts (DD) and washers (CC) per
caster.
□ Tighten all bolts with a
□ Return the rolling cabinet (B) to its upright position.
CC
DD
4
Installing the pegboard brackets
NOTE: The holes in the cabinet are tapped and do not
require nuts.
□ Attach the pegboard bracket ) to the cabinet (B) and
pegboard (Q) using four bolts (BB) per bracket.
□ Tighten all bolts securely.
AA
6
6
□
nuts.
on top of the
13
mm wrench.
I
CC
DD
□
(P
)
B
G
Q
P
BB
B