Kohler K-1114-GLF Roughing-In Manual page 2

No change in measurements if connected with
drain illustrated. (K-11677 or K-11677M)
Recommended faucet area
1-1/4"
(3.2 cm)
Tile Flange
Detail
42" (106.7 cm)
1-1/2" OD
Product Information
Applicable product:
Drop-in, 3-side integral flange, left drain
Drop-in, 3-side integral flange, right drain
Fixture*:
Bathing well
Basin area 55" (139.7 cm) x 23-1/4" (59.1 cm)
bottom
Basin area top 64" (162.6 cm) x 32" (81.3 cm)
Weight 132 lbs (60 kg)
To overflow
Water depth 15" (38.1 cm)
Capacity 78.5 gal (297 L)
* Approximate measurements for comparison only.
Drop-in cutout dimensions:
70-1/2" (179.1 cm) x 40-1/2" (102.9 cm)
Blower motor: Heater
300 W
Minimum access panel pump/control:
20" (50.8 cm) W x 15" (38.1 cm) H
1076053-1-B
1-1/2"
(3.8 cm)
Drop-In Rim
Detail
Blower/Control Access
20" (50.8 cm) W x
15" (38.1 cm) H Min
1-1/4" (3.2 cm)
21"
19-1/2"
(53.3 cm)
(49.5 cm)
K-1114-GLF
K-1114-GRF
V Hz
120 60
required
1" (2.5 cm) from
the Floor to the
Bottom of the Drain
Required Electrical Service
Dedicated circuit required, protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control
Blower motor is supplied with a 24" (61 cm) grounding-type
plug-in cord.
Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum of
39 lbs/square foot (190 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no interference
with the drain overflow and circulating system before drilling any
holes. Consult local and national codes for minimum air gap
requirements if installing a spout on the faucet deck.
The hot water supply should be 70% of the capacity of the bath or
greater. Installations will vary.
This fixture conforms to ANSI Standard Z124.1.2. All dimensions
are nominal.
A
5
2
11-1/16"
(28.1 cm)
72" (182.9 cm)
120 V, 5 A, 60 Hz
21"
(53.3 cm)
3-3/4"
(9.5 cm)
1-1/4"
(3.2 cm)
3-1/2"
(8.9 cm)
2-7/8" (7.3 cm)
3" (7.6 cm)
Kohler Co.