Asus PRIME H310I-PLUS R2.0 User Manual page 14

Audio 2.1, 4.1, 5.1 or 7.1-channel configuration
Port
Light Blue (Rear panel)
Lime (Rear panel)
Pink (Rear panel)
Lime (Front panel)
To configure a 7.1-channel audio output:
7. USB 3.1 Gen 1 (up to 5Gbps) ports. These 9-pin Universal Serial Bus (USB) ports
are for USB 3.1 Gen 1 devices.
•
•
•
8. DVI-D port. This port is for any DVI-D compatible device.
DVI-D can not be converted to output from RGB Signal to CRT and is not compatible with
DVI-I.
9. HDMI port. This port is for a High-Definition Multimedia Interface (HDMI) connector,
and is HDCP compliant allowing playback of HD DVD, Blu-ray, and other protected
content.
10. USB 2.0 ports. These 4-pin Universal Serial Bus (USB) ports are for USB 2.0 devices.
1-6
Headset
2.1-channel
Line In Rear Speaker Out
Line Out Front Speaker Out
Mic In
-
Use a chassis with HD audio module in the front panel to support a 7.1-channel audio
output.
USB 3.1 Gen 1 devices can only be used for data storage.
We strongly recommend that you connect USB 3.1 Gen 1 devices to USB 3.1 Gen 1
ports for faster and better performance from your USB 3.1 Gen 1 devices.
Due to the design of the Intel
USB 2.0 and USB 3.1 Gen 1 ports are controlled by the xHCI controller. Some legacy
USB devices must update their firmware for better compatibility.
4.1-channel 5.1-channel
Rear Speaker Out
Front Speaker Out
Mic In Bass/Center
-
300 series chipset, all USB devices connected to the
®
Chapter 1: Product introduction
7.1-channel
Rear Speaker Out
Front Speaker Out
Bass/Center
- Side Speaker Out