Table of Contents
Advertisement
4.10.7 Geometric Distortion By Luminance
The test pattern is composed of two white areas and a black area, the three areas are equivalents. The
input signal level is 700 mV with brightness control at cut-off and contrast control at maximum(see
Figure 12).
The distortion introduced by dynamic High Voltage variation, due to different brightness level on the
screen, are admitted with following limits:
4.10.8 Linearity
The linearity of an image displayed on the CRT must meet the following requirements, with reference to
figure 13 for both X and Y axis.
The measured value of linearity shall be less than 6% when calculated using all lattices and shall be less
than 4% when calculated using adjacent lattices.
Where: X max and X min are belong to the set Xi,i=1......8
|AC - BD| or |A'C'-B' D'|≦2.0mm
Figure 12
X1 X2 X3 X4 X5 X6
Y1
Y2
Y3
Y4
Y5
Y6
Y7
Y8
Figure 13:Linearity
−
X
max
X
min
Y
max
OR
+
X
max
X
min
Y
max
X max, X min, be Calculated Same Line
Y max, Y min, be Calculated Same Row
Y max and Y min are belong to the set Yi,i=1....8
X7
X8
−
Y
min
+
Y
min
18
Advertisement
Table of Contents
