Switching The Power; Adjusting Display Settings; External Controls; Osd Options - Acer AL2016W Manual

(1) Power Cord
(2) VGA Cable
(3) DVI Cable (option)
WARNING: The D-Sub 15 pin plug of the VGA cable is trapezoid in shape. Make sure the shape of the plug matches
the shape of the socket it is inserted into, and that none of the pins are bent or otherwise damaged.
Operating Your Monitor
First, switch the power on to the monitor, then switch the power on to the computer. When you see the LED on
the power button go green, this indicates the computer is ready for use. Allow about 10 seconds for the video
signal to appear. If you do not see the green light on the power button or a video signal, check the connections .
AUTO
1
2
4
MENU

OSD Options

Please refer to "External Controls " on Page 5. To adjust the OSD settings :
1. Press the MENU button to open the OSD menu .
2. Use the buttons marked < or >, to highlight a control, then press the MENU button to enter
3. Use the buttons marked < or >, to adjust the control to the desired level.
4. When you have finished making all selections, press the MENU button to exit the OSD. (Or the adjustment
will auto-save after 20 seconds.)
Attach the monitor to the power cord which should then be
inserted into a properly grounded electric socket.
Connect the signal cable to the VGA output socket of the graphics card
on the computer. Then tighten the thumbscrews on the connector
Connect the signal cable to the DVI output socket of the graphics card
on the computer. Then tighten the thumbscrews on the connector
If OSD is active, press to exit. If OSD is inactive, press and the
monitor will automatically optimize the display position, clock and
Auto Configuration
phase of your display.
If OSD is active, press to select or adjust OSD options.
Minus
If OSD is active, press to select or adjust OSD options.
Plus
Press to view OSD. Press AUTO to exit.
OSD Menu
Power on/off
Power Green: power on
Orange: in sleep mode