Error Symptoms List - Acer Veriton L4610G Service Manual

Error Symptoms List

NOTE: To diagnose a problem, first find the error symptom in the left column. If directed to a check
procedure, replace the FRU indicated in the check procedure. If no check procedure is indicated,
the first Action/ FRU listed in right column is the most likely cause.
Error Symptom
NOTE: Normally, the processor fan should be operative, and the processor clock setting should be exactly set to
match its speed requirement before diagnosing any processor problems.
Processor fan does not run but power supply fan
runs.
Processor test failed.
NOTE: Ensure the memory modules are installed properly and the contact leads are clean before diagnosing any
system problems.
Memory test failed.
Incorrect memory size shown or repeated during
POST.
System works but fails to enter power saving
mode when the Power Management Mode is set
to Enabled.
Blinking cursor only; system does not work.
NOTE: Ensure hard disk drive is configured correctly in BIOS Setup, cable/jumper are set correctly before
diagnosing any hard disk drive problems. (If only one drive is installed, please make sure the drive is connected
to master connector or the drive is set to master.)
Hard disk drive test failed.
Hard disk drive cannot format completely.
Hard disk drive has write error.
Hard disk drive LED fails to light, but system
operates normally.
60
Processor / Processor Fan
1. Ensure the system is not in power saving mode. See
"Power Management" in chapter 2.
2. With the system power on, measure the voltage of
processor fan connector. Its reading should be
+12Vdc. Its reading should be +12Vdc. If the reading
shows normal, but the fan still does not work, then
replace a good fan.
3. Main board.
1. Processor.
2. Main board.
Main board and Memory
1. See "Memory"
2. Main board
1. Insert the memory modules in the DIMM sockets
properly, then reboot the system.
2. Memory module.
3. Main board.
1. Enter BIOS Setup and load default settings.
In Windows Systems, check settings in Power
Management Property of Control Panel.
2. Reload software from Recovery CD.
1. Diskette/IDE drive connection/cables
2. Diskette/IDE disk drives
3. See "Undetermined Problems".
4. Main board
Hard Disk Drive
1. Enter BIOS Setup and Load default settings.
2. Hard disk drive cable.
3. Hard disk drive
4. Main board.
1. Enter BIOS Setup and Load default settings.
2. Hard disk drive cable.
3. Hard disk drive.
4. Main board.
1. Enter BIOS Setup and Load default settings.
2. Hard disk drive.
1. With the system power on, measure the voltage of hard
disk LED connector.
2. Hard drive LED cable.
Action/FRU