Leveling Unit; Kickplate Installation - Viking VRI7240 Installation Manual

Leveling Unit

Once the unit is in position, height adjustment can be made from
the front. Remove access panel just below the water fi lter. Using a
5/16" hex drive, turn clockwise to raise the unit or counterclockwise
to lower. Use the lowest torque setting when using a power drill.
Do not turn the leveling legs by hand. When the unit is properly
leveled, door/drawer adjustments are less likely to be necessary.
IMPORTANT NOTE:
Level the unit to the fl oor, not surrounding
cabinetry. This could aff ect the operation of the unit, such as door
closing.

Kickplate Installation

After the unit has been adjusted to the proper height, place the kickplate on the lower front with the adjustment screws in the slots. Let the
kickplate drop until it hits the fl oor. Tighten the screws.
Adjustment slot
Adjustment screws
Left Front
Adjustment
Left Rear
Adjustment
kickplate
20
Front Panel
B
A
Right Rear
Adjustment
Right Front
Adjustment
Front of unit