Table of Contents
Advertisement
HORIZONTAL ADJUSTMENT
•
Slightly loosen the nuts securing the bagger RH and LH
hor i zon tal adjustment brackets. Loosen only enough
so the brackets keep their position, but allow them to
be moved.
•
Move the brackets the amount forward or back ward
you wish the bag assembly to move. Retighten the
nuts securely.
VERTICAL ADJUSTMENT
•
Slightly loosen the nuts securing the vertical adjustment
brackets. Loosen only enough so the brackets keep
their position, but allow them to be moved.
•
Move the brackets the amount up or down you wish the
bag assembly to move. Retighten the nuts securely.
•
Reinstall the bagger as sem bly and check the bagger
to fender fit. If necessary, repeat the procedure until
proper fit is attained.
•
After proper fit is attained, remove bagger from tractor
and install bagger latch to tractor back plate as shown.
Tighten securely.
•
Install and carefully lower bagger to actuate latch.
TOP SURFACES
EVEN
HOR I ZON TAL
AD JUST MENT
BRACKET
VERTICAL
AD JUST MENT
BRACK ET
•
Measure distance between bagger and latch as shown.
If distance is not 10mm - 16mm carefully remove bag-
ger and repeat vertical adjustment as needed.
10MM (7/16") - 16MM (5/8")
TO ASSEMBLE AND INSTALL MULCHER
PLUG (If Equipped) (See Fig. 13)
•
Remove spring retainer and pin from handle.
•
Insert plug into handle. Make sure that the letter "A"
on both the plug and handle are on the same side and
that they can both be seen from the top when laying
on the ground.
ASSEMBLY
6MM (1/4") - 9MM (3/8")
02967
Fig. 11
BAGGER LATCH
Fig. 12
•
Secure with pin and retainer spring pro vid ed. For in stal-
la tion see "To Convert Mow er" in Operation sec tion of
this manual.
TO INSTALL HOOD SCOOP (See Fig. 14)
9
HAN DLE
RE TAIN ER
SPRING
PIN
PLUG
Fig. 13
Fig. 14
Hide quick links:
Advertisement
Table of Contents
