Acer RC271U Quick Start Manual

Acer LCD Monitor Quick Start Guide (QSG)
Important safety instructions
Please read the following instructions carefully.
1 To clean the LCD monitor screen:
• Turn off the LCD monitor and unplug the power cord.
• Spray a non-solvent cleaning solution onto a rag and clean the screen gently.
• NEVER SPRAY OR POUR ANY LIQUID DIRECTLY ONTO THE SCREEN OR CASE.
• PLEASE DO NOT USE ANY AMMONIA OR ALCOHOL-BASED CLEANERS ON THE LCD DISPLAY SCREEN OR CASE.
• Acer will not be liable for damage resulting from use of any ammonia or alcohol-based cleaners.
2 Do not place the LCD monitor near a window. Exposing the monitor to rain, moisture or sunlight can severely damage it.
3 Do not apply pressure to the LCD screen. Excessive pressure may cause permanent damage to the display.
4 Do not remove the cover or attempt to service this unit yourself. An authorized technician should perform servicing of any nature.
5 Store the LCD monitor in a room with a temperature of -20° to 60° C (-4° to140° F). Storing the LCD monitor outside this range may
result in permanent damage.
6 Immediately unplug your monitor and call an authorized technician if any of the following circumstances occur:
• Monitor-to-PC signal cable is frayed or damaged.
• Liquid spills onto the LCD monitor or the monitor is exposed to rain.
• The LCD monitor or case is damaged.
7 Make sure to use a wall mount bracket which has at least 7 cm distance from the wall.
Package contents
Quick start
LCD monitor
guide
RC271U
RC1 Series
USER GUIDE
Attaching the monitor to the base
1 Carefully remove the monitor from its packaging.
2 Take only screen out from package and put on a clean and stable surface with screen face down.
3 Secure the monitor base with neck by turning the silver screws (at the bottom of the base).
4. Connect the stand to the screen
Connecting your monitor to a computer
1 Turn off your computer and unplug your computer's power cord.
2 Connect the signal cable to the DVI-D (optional) and/or HDMI (optional) and/or DP (optional) input socket of the monitor, and the
DVI-D (optional) and/or HDMI (optional) and/or DP (optional) output socket of the graphics card on the computer.Then tighten the
thumbscrews on the signal cable connector.
3 Connect one end of the adapter to the monitor and the other end to a properly grounded, AC outlet.
4 Plug the power cords of your computer and your monitor into a nearby electrical outlet.
5 Connect the audio cable (Optional).
Connect an audio cable to the audio port of the monitor.
Note: Audio output is only for audio output model. Please check user
manual for more instruction.
HDMI
DVI-IN
HDMI
AC AC Power
cable
Adapter cord
(Optional)
HDMI
DVI-IN
HDMI
DP
AUDIO IN
HDMI DP DC IN
DVI-DL (Dual Link) Audio cable
cable (Optional) (Optional)
DP cable
(Optional)