Table of Contents
Advertisement
COLD WEATHER START UP
The Cold Weather Clutch enables the engine to be started without having to pull through cold, thickened
hydraulic fluid. Simply push the handle in to the locked position. Start engine, let it warm up, and release
Cold Weather Clutch.
SPLITTER OPERATION
1. Set up the log splitter in a clear, level area and block the wheels. The suction port on the tank should always
be on the lower side of the log splitter.
2. Place a log on the beam, against the foot plate. Make sure the log is securely on the foot plate and up
against the beam.
3. Depress the valve lever so that the cylinder will drive the wedge into the log. Extend the cylinder until the
log splits or to the end of its stroke. If the log has not completely split after the cylinder has reached the end
of its extension, retract the cylinder. NOTE: Leaving the valve in the "actuate" position at the end of the
stroke may damage the pump. Always use extra care when splitting logs with ends that are not square.
NOTE:
To extend the life of the hydraulic cylinder, avoid "BOTTOMING OUT" the cylinder.
4. When using the Log Splitter in the vertical position, make sure the beam latch is engaged as shown below.
Pull the bent pin outward then twist and release it to hold the I-beam in place.
TOWING SAFETY
This unit should not be towed on any street, highway, or public road without checking the existing federal, local, and
state laws. Any licensing or modifications such as taillights, etc., need to comply with existing federal, local, or state
vehicle requirements is the sole responsibility of the purchaser. Obey all regulations when towing on public roads
SAFETY PRECAUTIONS.
and highways. See also
Turn the fuel shut-off valve OFF to prevent flooding of the engine while traveling.
Be careful when backing up. You can easily jack-knife your splitter.
TOWING AT NIGHT
The requirements for taillights are based on States regulations. Some states allow towing at night as long
as the towed equipment does not visibly impair the tow vehicle taillights. This is based on a state, to state
requirements. The customer is responsible for meeting the states requirements.
If a "Statement of Origin" is required in your state, see your local dealer to receive one.
HYDRAULIC SAFETY
The hydraulic system on your splitter requires careful inspection along with the mechanical parts. Be sure to replace
any frayed, kinked, cracked or otherwise damaged hydraulic components. Just because it isn't leaking today doesn't
mean that it will not fail tomorrow.
7
Advertisement
Table of Contents
