Table of Contents
Advertisement
OPERATING PROCEDURE
7. Removing the indoor fan motor and the line flow fan
(1) Remove the panel (refer to 1.) and the corner box.
(2) Remove the SW holder, the display P.C. board holder,
the electrical box (refer to 3.) and the nozzle assem-
bly (Refer to 4.).
(4) Remove the screws fixing the motor bed. (Photo 7)
(5) Loosen the screw fixing the line flow fan. (Photo 8)
(6) Push the upper part of the water cover and unhook
the catch.
(7) Pull the water cover to the right to remove it.
(8) Remove the motor bed together with fan motor and
motor band.
(9) Release the hooks of the motor band. Remove the
motor band. Pull out the indoor fan motor.
(10) Remove the screws fixing the left side of the heat
exchanger. (Photo 12)
(11) Lift the heat exchanger, and pull out the line flow fan
to the lower-left.
OBH555D
Photo 7
Catches of the water cover
Photo 8
Photo 9
Screws of the
left side of the
heat exchanger
33
PHOTOS
Motor band
Screws of the
motor bed
Screw of the
line flow fan
Advertisement
Table of Contents
