Table of Contents
Advertisement
Loading the Trailer
1.
While maintaining control of the trailer bed and
holding onto the handle, press down on the latch
assembly and the lift handle
the trailer bed to the ground.
1. Latch assembly
2.
On flat ramps, pivot the wheel rods upward
(Figure
13) and on rail ramps, rotate the wheel
rods parallel (open) to the ramp
3.
Remove the basket from the greens mower,
disengage the reel drive, and move the throttle
to the slowest position. Slowly drive the greens
mower onto the trailer until you contact the
wheel stops
(Figure
4.
If the rail wheels are not centered on the rails,
loosen the fasteners securing the rails to the
trailer and adjust the rail position so that the rail
wheels are centered, then tighten the fasteners.
5.
Shut off the engine and engage the parking
brake.
6.
Engage the wheel rods as follows:
•
On flat ramps, rotate the wheel rods
downward over the greensmower transport
wheels
(Figure
•
On rail ramps, lift the wheel rod and rotate it
behind the greensmower transport wheels
(Figure
14).
(Figure
11). Lower
Figure 11
2. Handle
(Figure
12).
13).
g014670
Greensmower loaded on a TransPro 80 with Rail Kit
14).
1. Wheel rod (shown in pivoted down position)
6
Figure 12
Figure 13
g214902
g014671
Advertisement
Table of Contents
