Advanced
The Advanced screen contains parameters involving your hardware devices. It also provides advanced
settings of the system.
FIR Ports
Configure the system's infrared port using options: Disabled and Enabled.
Information
Infrared Port (FIR) :
Base I/O address/IRQ:
DMA channel:
F1
Help
Esc
Exit
The table below describes the parameters in the screen. Settings in boldface are the default and suggested
parameter settings.
Parameter
FIR I/O Settings
DMA Setting for Fast
IR
38
Phoenix cME FirstBIOS Pro Setup Utility
Main
Advanced
[Enabled]
[2F8/IRQ 3]
[DMA 3]
Select Item
F5/F6
Select Menu
Enter
Description
Sets the base I/O address and IRQ for
Infrared port.
Sets a DMA channel for the printer to
operate in ECP mode. This parameter is
enabled only if Mode is set to ECP.
Security
Change Values
Select
Sub-Menu
Boot
Item specific Help
[Disabled]
Infrared port is not
active.
[Enabled]
Infrared port is active
and is user configured.
F9
Setup defaults
F10
Save and Exit
Option
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
DMA1
DMA3
Exit
Chapter 2