Arts (Automatic Range Transponder System); Basic Arts Setup And Operation - Yaesu FT-4XE Advance Manual

Vhf/uhf dual band fm transceiver
Hide thumbs Also See for FT-4XE:
Table of Contents

Advertisement

ARTS (Automatic Range Transponder System)

The ARTS feature uses DCS signaling to inform both parties when another ARTS
equipped station is within communications range. This may be particularly useful during
Search and Rescue situations, where it is important to stay in contact with the other
members of the group.
The stations must set up their DCS codes to the same code number, and then activate
their ARTS feature using the command appropriate for their transceiver. Alert ringers
may be activated, if desired.
Whenever the PTT switch is pressed, or every 15 or 25 seconds after ARTS is activated,
the transceiver will transmit a signal which includes a (subaudible) DCS code for about
one second. If another ARTS enabled transceiver is in range, the beeper will sound and
the display will show "IN.RNG". When the other transceiver is out of range, "OUT.RNG"
is shown when the ARTS function is in operation.
Whether or not the PTT switch is pressed, the transceiver
may be programmed to transmit a CW ID, every 10 min-
utes.
If you move out of range for more than one minute (four pollings), the transceiver will
sense that no signal has been received, three beeps will sound, and the display will re-
vert to "OUT.RNG" If you move back into range, the transceiver will again beep, and the
display will change back to the "IN.RNG" indication.
During ARTS operation, it is not possible to change the operating frequency or other set-
tings. In order to resume normal operation, ARTS must be terminated. This is a safety
feature designed to prevent accidental loss of contact due to channel change, etc.

Basic ARTS Setup and Operation

1. Set all the transceivers to the same DCS code number, per the instructions on page
6.
2. Press and hold the [2] key.
• ARTS polling will starts.
• "OUT.RNG" will be displayed on the LCD.
3. Every 25 seconds, the transceiver will transmit a "polling" call to the other station.
• When that station responds with its own ARTS polling
signal, the display will change to "IN.RNG" to confirm
that the other station's polling code response was re-
ceived.
18

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ft-4xr

Table of Contents