Using Your Pc68Ltx; Turn Pc68Ltx On/Off; Cb Mode - Uniden Bearcat PC68LTX Owner's Manual

Negative Ground System
With a negative ground system, the negative (-) battery terminal is
usually connected to the vehicle motor block.
Connect the red DC power cord from the
transceiver to the positive (+) battery terminal
or other convenient point. Then connect the
black power cord to the vehicle chassis or negative (-) battery terminal.

USING YOUR PC68LTX

TURN PC68LTX ON/OFF

Turn the VOLUME knob clockwise until the unit turns on and the display
backlight turns on.
Turn the VOLUME knob counter-clockwise to turn the unit off.

CB MODE

Be sure that the power source, antenna, and microphone are properly
connected before proceeding.
1. Turn unit on. Set volume to a comfortable level.
2. Set switch to CB.
3. Turn the CH knob to select a CB channel.
4. Set noise limitations switch to NB/ANL.
5. Adjust squelch.
Turn SQUELCH knob fully clockwise so only strong signals can
•
get through.
Turn SQUELCH knob fully counterclockwise until you hear a
•
hiss. Everything gets through - noise, weak signals, and strong
signals
Turn SQUELCH knob clockwise until the hiss stops. Only
•
clearer signals get through.
Set SQUELCH only when the radio is not receiving a strong signal.
6. Press and hold PTT and check the multifunction meter. It will
show the RF output power.
7. Turn RF GAIN knob to set RF gain sensitivity. Normally, the knob is
9