Removing An Sfp Transceiver - 3Com 3226 User Manual

5 The transceiver connects to the network using a duplex SC connector.
6 Connect the other end of the cable to a device fitted with an appropriate
7 Check the Module Active LEDs on the front of the Switch to ensure that it
Removing an SFP
Transceiver
1 Disconnect the cable from the transceiver.
2 Move the wire release lever downwards until it is pointing toward you.
3 Pull the wire release lever toward you to release the catch mechanism;
Figure 6 Inserting a SFP Transceiver
Attach a male duplex SC connector on the network cable into the duplex
SC connector on the transceiver.
Gigabit Ethernet connection.
is operating correctly. Refer to "LEDs" on page 14 for more information.
If you wish to remove a 3Com transceiver (it is not necessary to
power-down your Switch):
the transceiver will then easily slide out.
The above procedure will release a 3Com SFP transceiver. To release a
transceiver from another manufacturer see the documentation supplied
with your SFP transceiver.
SFP Operation 27