Volvo 2010 S80 Owner's Manual page 91

2. With the light switch in position
the turn signal lever toward the steering
wheel to position to toggle between
high and low beams (this also applies on
models equipped with the optional Active
Bending Lights).
> The symbol
illuminates in the
instrument panel to indicate that the
high beams are on.
Active Bending Lights (ABL)*
Headlight pattern with the Active Bending Light
function deactivated (left) and activated (right)
When this function is activated, the headlight
beams adjust laterally to help light up a curve
according to movements of the steering wheel
(see the right-pointing beam in the illustration).
ABL is activated automatically when the engine
, pull
is started and it can be deactivated/reactivated
in the menu system under
Light settings Active bi xenon
NOTE
This function is only active in twilight or dark
conditions, and only when the vehicle is in
motion.
If a fault should occur in the system, the symbol
will illuminate and a message will be displayed
as shown in the table.
Symbol Display
Headlamp
failure
Service
required
03 Your driving environment
Parking lights
Car settings
lights.
Headlight control in position for parking lights
The front and rear parking lights can be turned
Explana-
on even when the ignition is switched off.
tion
Turn the headlight control to the center posi-
The system
tion (the license plate lighting comes on at the
is not func-
same time).
tioning
The lighting also comes on when the trunk is
properly and
opened in order to alert anyone traveling
should be
behind your vehicle.
inspected/
repaired by
a trained
and qualified
Volvo serv-
ice techni-
cian.
*
Option/accessory, for more information, see Introduction.
Lighting
03
``
91