Volvo 2009 S60 Owner's Manual page 76

02 Instruments and controls
Mirrors
To do so:
1. Switch the ignition to position II.
02
2. Press the button on the rear side of the
mirror with straightened paperclip or simi-
lar object for approximately 3 seconds until
ZONE
is displayed.
> The number of the current magnetic
zone will also be displayed.
3. Press the button repeatedly until the num-
ber for the desired zone (1-15) is displayed.
After several seconds, the compass heading
will again be displayed, and the change of
magnetic zones is complete.
Z
C
O
A
N
L
E
Calibrating the compass
76
Calibrating the compass
•
Stop the car in a large, open area, away
from traffic.
•
Turn off as many electrical devices in the
car as possible to avoid interference with
the compass (e.g. audio system, etc).
•
Using a pen or similar object, hold the but-
ton (1) depressed for at least 6 seconds.
" CAL " will be displayed.
•
Drive slowly in a circle at a maximum speed
of 5 m.p.h. (8 km/h) until CAL
displayed.
NOTE
This step can also be done by driving nor-
mally until CAL is no longer displayed.
Calibration is complete.
Power door mirrors
is no longer
The mirror control switches are located on the
driver's door armrest.
Driver's side
Press the L switch (an LED in the switch will
light up) to activate the adjustment control and
then use this control to adjust the driver's door
mirror.
Passenger's door
Press the R switch (an LED in the switch will
light up) and then use the adjustment control
to adjust the passenger's door mirror.