Saturn 2006 Relay Owner's Manual page 390

Once the center cap and/or wheel cover are removed,
use the following steps to remove the flat tire and install
the spare tire.
Notice: If your vehicle has wheel locks and you
use an impact wrench to remove the wheel nuts, you
could damage the lock nut or wheel lock key. Do
not use an impact wrench to remove the wheel nuts
if your vehicle has wheel locks.
Notice: If you use a jack to raise the vehicle
without positioning it correctly, you could damage
your vehicle. When raising your vehicle on a
jack, avoid contact with the rear axle control arms.
5-76
1. Loosen the wheel nuts
using the folding
wrench, but do not
remove them.
Turn the handle
counterclockwise
about 180 degrees,
then flip the handle
back to the starting
position. This avoids
taking the wrench
off the lug nut for
each turn.
Notice: If you position the jack under the rocker
molding and attempt to raise the vehicle, you could
break the molding and/or cause other damage to your
vehicle. Always position the jack so that when the
jack head is raised, it will fit firmly in the notch
located inboard from the rocker molding.
A. Front Location
B. Rear Location
2. Near each wheel, there is a notch (A and B) in the
vehicle's frame, inboard of the rocker molding.
Position the jack and raise the jack head until it fits
firmly into the notch in the vehicle's frame nearest the
flat tire.
Do not raise the vehicle yet.