Pontiac 2006 G6 Owner's Manual page 87

If you enter the vehicle after a remote start, and the
engine is still running, insert the key into the
ignition switch and turn to ON to drive the vehicle.
4. To manually shut off a remote start, do any of the
following. The parking lamps will turn off to indicate
the engine is off.
•
Aim the remote keyless entry transmitter at
the vehicle and press and release the remote
start button.
•
Turn on the hazard warning flashers.
•
Turn the ignition switch ON and then OFF.
Your vehicle's engine can be started two times, per
ignition cycle, using the transmitter's remote start
feature. If only one remote start procedure has been
done, since last driving the vehicle, or resetting
the remote start system, the engine may be started
again remotely by following the remote start procedure
a second time.
If the remote start procedure is used again before the
first 10 minute time frame has ended, 10 minutes will be
added to the remaining time. The added 10 minutes
are considered a second remote start.
The remote vehicle start feature will not operate if any
of the follow occur:
•
The remote start system is disabled through
the DIC.
•
The vehicle's key is in the ignition.
•
The vehicle's hood is open.
•
The hazard warning flashers are on.
•
The check engine light is on. See Malfunction
Indicator Lamp on page 3-40.
•
The engine coolant temperature is too high.
•
The oil pressure is low.
•
Two remote vehicle starts have already been
provided for that ignition cycle.
Vehicles that have the remote vehicle start feature are
shipped from the factory with the remote start system
enabled. The system may be enabled or disabled
through the DIC. See "REMOTE START" under DIC
Vehicle Personalization on page 3-52 for additional
information.
2-9