Tub Clean - LG F1069FDF Owner's Manual

7. Tub clean -

To clean the tub, please run the TUB CLEAN cycle.
Entering Tub Clean
in ready/idle mode.
Pay type: Price is
displayed.
OPL type: PUSH is
displayed.
Enter setup mode.
You will see LqC1
NOTE
• Never load any laundry when using TUB CLEAN. The clothes may be damaged or become
contaminated. Make sure to clean the washer tub when it is empty.
• Leave the door open after finishing the laundry to keep the tub clean.
• TUB CLEAN should be used weekly.
• Safely and conveniently secure the door slightly ajar with the magnetic door plunger. This will
promote air circulation and allow the interior of the machine to dry.
Press and hold the Warm button for at least 3 seconds.
Display shows default number of Tub Clean cycle runs
per operation.
Press the Warm(+) or Cold(-) button to select the
number of Tub clean cycle runs. (1~3)
Press the Start button.
Display will show the remaining time and Tub Clean
starts.
When the TUB CLEAN cycle is finished,
displayed with beeping.
Go back to ready mode.
Press the Warm or the Cold button until
in the display.
Press the Start button.
Display will show the remaining time and Tub clean
Start.
When the TUB CLEAN cycle is finished,
displayed with beeping.
Go back to ready mode.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready
mode.
• Coin type - Turn on/off toggle switch.
• Card type - Pull the service card.
• All types - Push the Hot button twice.
PROGRAMMING MODE - TEST MODE
Button
Button
Display
is
Display
appears
is
73