Storage Areas; Glove Box - Pontiac 2005 Bonneville Owner's Manual

Erasing HomeLink
To erase programming from the three buttons do the
following:
1. Press and hold down the two outside buttons until
the indicator light begins to flash, after 20 seconds.
Do not hold the two outside buttons for longer
than 30 seconds.
2. Release both buttons.
®
HomeLink is now in the train (learning) mode and can
be programmed at any time beginning with Step 2
under "Programming HomeLink
section.
Individual buttons cannot be erased, but they can be
reprogrammed. See "Reprogramming a Single
®
HomeLink Button" following this section.
Reprogramming a Single HomeLink
Button
To program a device to HomeLink
button previously trained, follow these steps:
1. Press and hold the desired HomeLink
not release the button.
2. The indicator light will begin to flash after
20 seconds. While still holding the HomeLink
button, proceed with Step 2 under "Programming
®
HomeLink " shown earlier in this section.
2-44
®
Buttons
®
" shown earlier in this
®
using a HomeLink
®
button. Do
®
Resetting Defaults
To reset HomeLink
1. Hold down the two outside buttons for about
20 seconds until the indicator light begins to flash.
2. Continue to hold both buttons until the HomeLink
indicator light turns off.
3. Release both buttons.
For questions or comments, contact HomeLink
1-800-355-3515, or on the internet at
www.homelink.com.

Storage Areas

Glove Box

®
Use the master key to lock and unlock the glove box.
To open it, lift the latch release on the left side of
the glove box door.
®
The VALET key, if equipped, will not work in the glove
box door lock.
®
to default settings do the following:
®
®
at