Advertisement
b.Floor drainage (S-Trap)
Please install the drain assembly and faucet as shown.
Please set the water supply and drainage position
according to the suppliers instructions. You can adjust
the height of shelf to fit the drain assembly.
3. Connect the hot and cold water supplies.
4. Attach the waste, and tighten securely.
5. Open the hot and cold water valves and check the supply
connections for any leaks.
6. Run water into the washbasin or vanity top, and check the
drain connections for any leaks.
USER MAINTENANCE
USER MAINTENANCE
WARNING! Risk of product damage.
Many cleansers contain abrasive and chemical substance
which is not suitable for cleaning stainless steel, enamel,
plating or plastic products. You may use mild cleansers or
soaps to clean the surfaces. Wipe any splashes of cleaner
solutions from the surface with clean soft cloth. Clean the top
in case hair dye or cosmetics drop on it to avoid color fading.
The top should be cleaned with water and detergent. Never
use a product which contains abrasive, liquid putty powder or
other similar products. If you try to maintain the top with
automobile wax on a regular basis, say, once a year, the
impermeability of the top will be greatly upgraded. In this way,
the little graffito and dirt on the top will be easily removed. If
the top blurs after several years' use, you could apply the
following method as a remedy to restore its luster. a) To
polish the surface of the top with a piece of 1200 abrasive
paper dipped with water. b) To work with a polishing paste. In
some countries, the temperature of hot water will exceed 60 .
Continuous use of this kind of hot water may lead to crack on
the top. Therefore, avoid to use water over 60
process of installing valves.
Please do not sit, lean or step on the top.
1408369-T01-A
b.
Outlet
Fig.3
3
3.
4.
5.
6.
b)
C
C
in the
-4-
(S
)
Faucet
Supply Lines
Shut-off Valve
Drain Assembly
Back Board
Ripple Pipe
a) 1200
60
60
Advertisement
