Advertisement
Quick Links
Luxon Bridge
Installation guide
1.
Before you start,
check the package contents
Luxon Bridge
DIN-rail clips (2x)
Blind plug for cable gland (2x)
Installation guide
Installation of electrical components must
be completed by a certified electrician as per
local codes and regulations.
2.
Mounting
1. Mount the Luxon Bridge to a wall or other flat mounting surface
using pan-head screws, max 4.5mm diameter.
2. Alternatively, in case of DIN-rail mounting, click the DIN-rail clips
into the rear of the Luxon Bridge.
3.
Wiring
Connect the Luxon Bridge to mains power.
(100-347Vac 50/60Hz)
Make sure the mains power source is not powered
during installation.
Connect the required sensor or switch to an I/O port.
www.nedap-luxon.com
p/n 9986294
EN–US
Language
Advertisement
Summary of Contents for Nedap Luxon Bridge
- Page 1 Mounting 1. Mount the Luxon Bridge to a wall or other flat mounting surface using pan-head screws, max 4.5mm diameter. 2. Alternatively, in case of DIN-rail mounting, click the DIN-rail clips into the rear of the Luxon Bridge.
- Page 2 5. If applicable, operate the mains switch, the green led must flash three times. Compatible sensors and switches Overview of compatible sensors and switches and their connections For possible sensors see Luxon Portal: https://portal.nedap-luxon.com. Connection → Signal wire 24V Supply...
- Page 3 Disclaimer By using this manual you accept the terms of this disclaimer. Nedap has made every effort to ensure that this manual is accurate. Nedap accepts no liability for any inaccuracies or omissions in this manual nor for any damages arising from or related to its use.