Table of Contents
Advertisement
(FPC Holder) to the DD Cylinder Unit before inserting the Flat Cable
(Flexible card) into the Flat Cable Holder. Pushing stopper portion
of the Flat Cable Holder with a small minus screw driver, remove
the Flat Cable Holder while paying attention for not to scratch the
DD Cylinder and not to break the Head Chip as shown below.
6.2.4. FLAT CARD CABLE INSTALLATION
When installing the Flat Card Cable on the connector, install the Flat Card Cable with the cable
contacts facing the connector contacts.
6.3. REMOVAL OF CASSETTE TAPE
When the cassette tape could not be uninstalled from an electrical malfunction, there are two
ways to remove a cassette tape.
1. Removal by compulsory unloading.
A. Press FF and EJECT button simultaneously for more than 3
seconds and set the Service Mode to 7.
B. Press STOP button in order to unload the mechanism.
(Pay attention to tape slack)
Service Mode Indication:
7 0L 00 (STOP) 7 0L A2 (EJECT)
2. Removal by manual operation by rotating the Loading Motor with
the batteries.
A. Disconnect the AC plug, and remove the Top Panel and the
Front Panel by referring to the Disassembly Procedures.
B. Connect one batterie (9V spec.) to the Loading Motor in series
for supplying 9V to rotate the Loading Motor.
PDF created with pdfFactory Pro trial version
12
www.pdffactory.com
Advertisement
Table of Contents
