Engine Oil Additives; When To Change Engine Oil - GMC 2000 Yukon XL Owner's Manual

As shown in the chart, SAE 5W
vehicle. However, you can use SAE 10W
_ _
-
to be 0 F ( 18 C) or above. These numbers on an oil
container show its viscosity, or thickness. Do not use
other viscosity oils, such as SAE 20W
NOTICE:
Use only engine oil with the American Petroleum
Institute Certified For Gasoline Engines starburst
symbol. Failure to use the recommended oil
can result in engine damage not covered by
your warranty.
R
GM Goodwrench oil meets all the requirements for
your vehicle.
If you are in an area where the temperature falls below
_ _
- -
20 F ( 29 C), consider using either an SAE 5W
synthetic oil or an SAE 0W
easier cold starting and better protection for your engine
at extremely low temperatures.
-
30 is best for your
-
30 if it's going
-
50.
-
30
-
30 oil. Both will provide

Engine Oil Additives

Don't add anything to your oil. The recommended oils
with the starburst symbol are all you will need for good
performance and engine protection.

When to Change Engine Oil

Your vehicle has a computer that lets you know
when to change your engine oil. This is not based on
mileage, but on engine revolutions and engine operating
temperature. When the computer has calculated that
the oil needs changing, the GM Oil Life System
indicate that a change is necessary. The mileage between
oil and filter changes will vary depending on how you
--
drive your vehicle usually between 3,000 miles
(5 000 km) and 7,500 miles (12 500 km) since your
last oil and filter change. Under severe conditions, the
system may come on before 3,000 miles (5 000 km).
Never drive your vehicle more than 7,500 miles
(12 500 km) or 12 months (whichever occurs first)
without an oil change.
The system won't detect dust in the oil. So, if you
drive in a dusty area, be sure to change your oil
and filter every 3,000 miles (5 000 km) or sooner.
Remember to reset the CHANGE ENGINE OIL
whenever the oil is changed.
t
will
6-13