Table of Contents
Advertisement
Programming your Stealth Cam Camera
NOTE: The following setting must be performed before you turn on the
camera.
1.
Select the time out interval by sliding the TIME OUT toggle switch to the
desired preset time interval in minutes.
2.
Select the resolution setting by sliding the RESOLUTION toggle switch to
the desired resolution setting.
3.
Select the capture mode by sliding the BURST toggle switch to the
desired amount of pictures or video you want to capture per triggering.
4.
Turn ON the Camera by sliding the CAM toggle switch to ON.
5.
Setting the Date / Time stamp:
a. Press and hold [SET] button for 2 seconds to enter Date / Time
setting mode.
b. The word TIME and HH will blink. Press [UP] or [DN] button to
adjust the hour.
c.
Press [SET] button to enter minute setting.
d. The word TIME and MM will blink. Press [UP] or [DN] button to
adjust the minute.
e.
Press [SET] button to enter the month setting.
f.
The word DATE and MM will blink. Press [UP] or [DN] button to
adjust the month.
g. Press [SET] button to enter date setting.
h. The word DATE and DD will blink. Press [UP] or [DN] button to adjust
the date.
www.wildviewcam.com
Toll Free 877-269-8490
USING THE CAMERA
Once all program settings have been setup properly, your Wildview Cam
camera is ready for field use.
Getting started
Listed below are some helpful pointers on how to use your camera to get the
best results.
•
Mount the camera about 4-5 feet high with the camera pointed at a slight
downward angle.
•
Mount the camera facing north or south NOT east or west due to the
rising and setting of the sun could produce false triggers and overexposed
images.
•
If you're covering a trail, face the camera down or up the trail. Most game
scouting cameras take 1-3 seconds to sense motion/heat and take a
picture.
•
Clear out any brush or weeds in front of camera. This will cause false
pictures caused wind or high temperature days.
•
Double check batteries before turning on the camera for use.
•
Make sure to insert the memory card after setting up the game camera.
•
Make sure to turn the camera to the ON position (or take out of Test
Mode) before you leave.
•
Verify time and date is correct.
www.wildviewcam.com
Toll Free 877-269-8490
i.
Press [SET] button to enter year setting.
j.
The word DATE and YY will blink. Press [UP] or [DN] button to adjust
the year.
k.
Press and hold [SET] button for 2 seconds to exit the setting mode
and enter into PIR count down mode.
l.
The TEST light will blink and display will show date and number of
pictures taken.
m. Once the program setting has been completed, slide the CAM toggle
switch to OFF position until you are ready for field use.
NOTE: Date & Time setting will be lost whenever the batteries are
removed from camera. Remember to re-set the Date & Time stamp after
you replace the batteries.
13
www.wildviewcam.com
Toll Free 877-269-8490
Mounting the camera with the supplied strap:
1.
Insert the strap through the strap slots on the rear housing.
2.
Wrap the strap around the mounting surface. Secure the strap and
tighten the buckle in order to secure the camera.
NOTE: In order to obtain proper weather resistance, please make sure
that both door latches are securely locked in place.
15
www.wildviewcam.com
Toll Free 877-269-8490
14
16
Hide quick links:
Advertisement
Table of Contents
