Securing A Child Restraint In The Center Front Seat Position - Chevrolet 2006 Colorado Owner's Manual

5. To tighten the belt, push down on the child restraint,
pull the shoulder portion of the belt to tighten the
lap portion of the belt and feed the shoulder
belt back into the retractor. If you are using a
forward-facing child restraint, you may find it
helpful to use your knee to push down on the
child restraint as you tighten the belt.
6. If your child restraint has a top tether, attach and
tighten the top tether to the top tether anchor.
Refer to the instructions that came with the child
restraint and to Lower Anchors and Tethers
for Children (LATCH) on page 1-46.
7. Push and pull the child restraint in different
directions to be sure it is secure.
1-58
To remove the child restraint, if the top tether is
attached, disconnect it. Unbuckle the vehicle's safety
belt and let it go back all the way. The safety belt
will move freely again and be ready to work for an adult
or larger child passenger. For outboard seating
positions, when the safety belt is not in use, slide the
latch plate up the safety belt webbing. The latch plate
should rest on the stitching on the safety belt, near
the upper anchor on the side wall.
Securing a Child Restraint in the
Center Front Seat Position
CAUTION:
{
A child in a child restraint in the center front
seat can be badly injured or killed by the right
front passenger's airbag if it inflates. Never
secure a child restraint in the center front seat.
It is always better to secure a child restraint in
the rear seat.
Do not use child restraints in this position. The restraints
will not work properly.