[Advanced Operation] Command-Based Control - Sharp PN-80TH5 Operation Manual

[Advanced operation]
Command-based control
You can control the monitor using RS-232C commands
(see page 47) via terminal software and other appropriate
applications.
In order to use this function, enable a connection to the
monitor through the web browser.
Read the manual for the terminal software for detailed
instructions.
(1) Connect the computer to the monitor.
1. Specify the IP address and data port number and
connect the computer to the monitor.
When connection has been established successfully,
[Login:] is returned as response.
2. Send the user name set in the SECURITY settings.
(See page 58.)
• Send [user name] + [
• If the user name is not set or if USE FOR Telnet
CONNECTION is set to OFF, send [
• When the transmission is successful, [
is returned as response.
3. Send the password set in the SECURITY settings. (See
page 58.)
• Send [password] + [
• If the password is not set or if USE FOR Telnet
CONNECTION is set to OFF, send [
• When the transmission is successful, [OK
returned as response.
(2) Send commands to control the monitor.
• The commands used are the same as those for RS-
232C. Refer to the communication procedure (see
page 44) for operation.
• Usable commands are provided in the RS-232C
command table. (See page 47.)
(3) Disconnect the connection with the monitor and
quit the function.
1. Send [BYE ].
When the transmission is successful, [goodbye] is
returned and the connection is disconnected.
TIPS
• Connection is automatically disconnected when the
time specified in AUTO LOGOUT TIME elapses over a
no-communication period.
].
].
Password:]
].
].
] is
Controlling the Monitor with a computer (LAN)
63
E