Table of Contents
Advertisement
08
Problem
Left/right audio channels are
inverted or only one side is
produced.
Multi-channel sound is not
output.
Noise can be heard when
outputting DTS Digital Audio
signals from the DIGITAL
OUT terminal.
192 kHz or 96 kHz digital
audio signals cannot be
output from the DIGITAL
OUT terminal.
Secondary audio or
interactive audio is not
output.
Audio is out of
synchronization
After a disc is inserted,
Loading stays displayed
and playback does not start.
is displayed in file names,
etc.
A message indicating low
memory appears while
playing a BD-ROM disc.
52
En
Check
Are the audio cables
properly connected?
Is the audio output of the
connected AV receiver or
amplifier, etc., properly set?
Is multi-channel sound
selected?
Is the connected AV receiver
or amplifier compatible with
DTS Digital Surround?
Is HDMI Audio Out properly
set?
Are Digital Output properly
set?
Are you listening to the audio
from a device connected with
an HDMI cable and a device
connected with a different
type of cable?
Are there too many files
recorded on the disc?
Remedy
Check whether the audio cables for the left and right channels are
inverted or whether the cable for one side is disconnected (page 18).
Read the operating instructions for the connected AV receiver or
amplifier and check the audio output settings of the AV receiver or
amplifier.
Use the menu screen or AUDIO to switch the disc's sound to multi-
channel.
If an AV receiver or amplifier that is not compatible with DTS Digital
Surround is connected to the DIGITAL OUT terminal, set Digital
Output to PCM (page 39).
• Copyright-protected audio is converted to 48 kHz or less before
output.
• Set Max Sampling Frequency to 96KHz or 192KHz (page 39).
When listening to the sound from an HDMI OUT terminal, set HDMI
Audio Out to Re-encode or PCM (page 39).
When listening to the sound from an DIGITAL OUT terminal, set
Digital Output to Re-encode or PCM (page 39).
The PQLS function works when the conditions are met when you have
connected an Pioneer AV receiver that supports PQLS to the HDMI
OUT terminal (page 16).
This means that the audio will be out of synchronization with the audio
from devices connected with different types of cables. If this happens,
set Control to Off (page 39).
When a disc on which files are recorded is inserted, depending on the
number of files recorded on the disc, loading may take several dozen
minutes.
The characters that cannot be displayed on this player are displayed
in
.
• Connect a USB device (page 18).
• Erase the data stored on the connected USB device from BUDA
Setup (page 42).
Advertisement
Table of Contents
