Windshield Wipers - Chevrolet 1999 Express Van Owner's Manual

As you signal a turn or a lane change, if the arrows flash
at twice the normal rate, a signal bulb may be burned
out and other drivers may not see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don't go on at all when you
signal a turn, check for burned
fuse (see "Fuses and Circuit Breakers" in the Index).
Headlamp High/Low Beam Changer
To change the headlamps from low beam to high or high
to low, pull the multifunction lever all the way toward
you. Then release it.
-
out bulbs and a blown
When the high beams are
on, this light on the
instrument panel also will
be on.

Windshield Wipers

For a single wiping cycle, turn the band to MIST. Hold
it there until the wipers start, then let go. The wipers will
stop after one cycle. If you want more cycles, hold the
band on MIST longer.
You can set the wiper speed for a long or short delay
between wipes. This can be very useful in light rain or
snow. Turn the band to choose the delay time. The
closer to LOW, the shorter the delay.
yellowblue
You control the windshield
wipers by turning the band
with the wiper symbol on it.
2-35