Storage Areas; Glove Box - Cadillac 2007 XLR Owner's Manual

Using Universal Home Remote
Press and hold the appropriate Universal Home
Remote button for at least half of a second.
The indicator light will come on while the signal is
being transmitted.
Erasing Universal Home Remote
Buttons
To erase programming from the three Universal
Home Remote buttons do the following:
1. Press and hold down the two outside buttons
until the indicator light begins to flash, after
20 seconds. Do not hold the two outside
buttons for longer than 30 seconds.
2. Release both buttons.
The Universal Home Remote is now in the training
(learning) mode and can be programmed at any
time beginning with Step 2 under "Programming
Universal Home Remote" shown earlier in
this section.
Individual buttons cannot be erased, but they can
be reprogrammed. See "Reprogramming a
Single Universal Home Remote Button" following
this section.
Reprogramming a Single Universal
Home Remote Button
To program a device to Universal Home Remote
using a Universal Home Remote button
previously trained, follow these steps:
1. Press and hold the desired Universal Home
Remote button. Do not release the button.
2. The indicator light will begin to flash after
20 seconds. While still holding the Universal
Home Remote button, proceed with Step
2 under "Programming Universal Home
Remote" shown earlier in this section.
For additional information on Universal Home
Remote, see Customer Assistance Offices
on page 485.

Storage Areas

Glove Box

To open the glove box, lift up on the lever. The
glove box has a light inside. Use the key to
lock and unlock.
121