Getting Started - VTech KidiZoom Smartwatch DX3 Instruction Manual

Optimum Operating
and Charging
Temperature
WARNING
Prolonged wearing of any watch can cause skin irritation for some people.
Clean the watch band regularly by wiping it with a damp towel. Be careful
not to get the watch wet, as this could damage the unit. Do not use soaps or
household cleaners, as they can get trapped under the band and irritate the
skin. Always dry the band before putting it back on. Irritation can also occur
if the band is too tight or too loose. If redness, swelling, itchiness, or any
other irritation occurs, remove the watch and consult a physician.

GETTING STARTED

MASTER POWER SWITCH
When you use KidiZoom
first time, slide the Master Power Switch (located
on the underside of the watch) to the On position,
using a small tool such as a paper clip if necessary.
Fully charge the watch before first use. A full charge
will take about three-and-a-half hours.
When the Master Power Switch is set to the Off
position, the unit will not function, and the battery
will not charge. Only move the switch to the Off
position if the watch will not be in use for an extended period of time.
Note: It is not necessary to switch off the watch in daily use. Once the
Master Power Switch is Off, the watch will stop functioning. After it is
turned on again, the time and date will have to be reset.
BATTERY RECHARGING
Note: Adult operation required.
The watch should be fully charged before first use. To charge the KidiZoom
Smartwatch DX3, connect the watch to a computer with the included
Micro-USB Cable. To do so correctly, please follow these steps:
Make sure that the Master Power Switch is set to the On position
•
before charging.
6
32°F - 104°F (0°C - 40°C)
® Smartwatch DX3 for the
®