Product Models - Cisco 250 Series Get To Know

Restoring Factory Default Settings
• Linux Kernel access during boot sequence
• Run time debug modes - allows Cisco support team to view device settings and apply protocol and layer 1 debug
commands and settings. The run time debug mode is accessible over telnet and SSH terminals in addition to console.
Restoring Factory Default Settings
To restore the switch to factory default settings, use the Reset button to reboot or reset the switch and do the
following:
• To reboot the switch, press and hold the Reset button for less than ten seconds.
• To restore the switch to its factory default settings:

Product Models

The following are the available product models:
Table 2: Product Models
SKU Name
SF250-24
SF250-24P
SF250-48
SF250-48HP
SG250-08
SG250-08HP
SG250-10P
SG250-18
SG250-26
SG250-26HP
SG250-26P
SG250-50
SG250-50HP
Get To Know Your Switch
8
• Disconnect the switch from the network or disable all DHCP servers on your network.
• With the power on, press and hold the Reset button for more than ten seconds.
Description
SF250-24 24-Port 10/100 Smart Switch
SF250-24P 24-Port 10/100 PoE Smart Switch
SF250-48 48-Port 10/100 Smart Switch
SF250-48HP 48-Port 10/100 PoE Smart Switch
SG250-08 8-Port Gigabit Smart Switch
SG250-08HP 8-Port Gigabit PoE Smart Switch
SG250-10P 10-Port Gigabit PoE Smart Switch
SG250-18 18-Port Gigabit Smart Switch
SG250-26 26-Port Gigabit Smart Switch
SG250-26HP 26-Port Gigabit PoE Smart Switch
SG250-26P 26-Port Gigabit PoE Smart Switch
SG250-50 50-Port Gigabit Smart Switch
SG250-50HP 50-Port Gigabit PoE Smart Switch
Get To Know Your Switch