Sony Bravia KDL-32L504 Operating Instructions Manual page 15

2
Secure the TV to the stand.
Use the optional hardware listed below (not supplied):
• M4 × 14 mm anchor bolt and M4 nut (screwed into the TV's Table-Top Stand).
• A screw or similar (attach it to the TV stand).
• Rope or chain (strong enough to support the weight of the TV). Make sure that there is no
excess slack in the rope or chain.
An alternative way to secure the TV is with an optional Sony Support Belt Kit.
3
Anchor the TV to the wall.
Use the hardware listed below (not supplied).
• Two anchor bolts, size M6 × 10-12 mm. Screw the bolts into the top-most wall-mount holes
located on the rear of the TV.
• Rope or chain (attach to one anchor bolt).
• Wall-anchor (attach to the wall stud) strong enough to support the weight of the TV (pass
the rope through the wall-anchor, then attach to the other anchor bolt).
Anchor bolts
• Contact Sony Customer Support to obtain the optional Support Belt Kit by providing your TV
model name.
United States call: 1-800-488-7669 or visit: www.sony.com/accessories
• Measure 2 provides minimal protection against the TV toppling over. For further protection,
follow all three measures recommended above.
• If an electric screwdriver is used, set the torque to tighten at approximately 1.5 N·m {15 kgf·cm}.
Anchor bolt
Nut
Wall-mount
holes
Rope or
chain
Screw hole
on the Table-
Top Stand
Screw
Wall-anchor
15