Hearth and Home Technologies WFM-RETROFIT Installation Instructions

Leave this manual with party responsible for use
and operation.
1. Introduction
The IntelliFire Wi-Fi Module Retrofit Kit (WFM-RETROFIT)
is designed to allow communication between the Hearth
& Home Technologies appliance and an Android or iOS
device.
The IntelliFire app allows the ability to control many of the
available features on the appliance. Also the IntelliFire
skill on Amazon Alexa or Google Assistant allows you to
turn on and off your appliance.
The IntelliFire Touch (IFT) Electronic Flame Control Mod-
®
ule (IFT- ECM) will have an IntelliFire Touch Wi-Fi label
above the Wi-Fi connector. This signifies the IFT-ECM is
Wi-Fi ready. See Figure 1.
Wi-Fi LABEL
Figure 1 Wi-Fi Label
Installation of the Wi-Fi Ready ECM into
2.
factory installed IFT controlled appliance
A. Precautions / Preparation
This device is tested and safe when installed in accor-
dance with this installation manual. Do not install any
components that may be damaged.
Do not modify, disassemble, or substitute any of the com-
ponents included with this kit. Installation of this kit must
be done by a qualified service technician.
For best performance, the location of the IntelliFire IFT-
WFM to the Wi-Fi router or your network extender should
be less than 50 feet from the appliance.
Preparation for Installation:
• Refer to the appliance installation manual for electri-
cal wiring of controls.
• Accessory installation manual for reference.
B. Kit Contents (WFM-RETROFIT)
• IFT-ECM - 2326-130
• IFT-WFM - 2326-137
1 Hearth & Home Technologies • Wi-Fi Capable ECM Upgrade Kit (WFM-RETROFIT) Installation Instructions • 2326-990 Rev. C • 7/20
Wi-Fi Capable ECM Upgrade Kit
WFM-RETROFIT
Installation Instructions
RUBBER COVER
Hearth & Home Technologies disclaims any responsibility
for, and the warranty will be voided by, the following actions:
• Installation and use of any damaged system component.
• Modification of the system component.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved
by Hearth & Home Technologies.
Any such action may cause a fire hazard.
• Read, understand and follow these instructions for safe
installation and operation.
C. Installation Steps
1.
Write the IFT-WFM Wi-Fi SSN# on top of the User
Guide. If you have multiple appliances to set up,
write the appliance description / location associated
with the IFT-WFM Wi-Fi SSN#. See Figure 2.
IFT-WFM
SSN #
Figure 2 IFT-WFM Wi-Fi SSN# Location
CAUTION! Do not install damaged components. If you
received components that are damaged, contact your
dealer for assistance.
Refer to appliance or accessory installation
manual for detailed instructions.
2. Remove power from appliance.
3. Locate the IFT-ECM in the control cavity of the
appliance and move the three-position switch to the
OFF position. See Figure 3.
4. Remove the rubber covers and verify the position of
50/30 and LP/NG switches on the old ECM you are
removing from the appliance. See Figure 3.
50/30
Figure 3 IFT-ECM Information
LP/NG