Advertisement
In case of a malfunction of the appliance, a failure indication is shown or some LED lights
are blinking: (depending on the dryer model you have, the failure is displayed in letters or by
different layouts of blinking LED lights)
Message displayed
F02
F05
F06
F13
F14
F15
LED is not blinking
AFTER-SALES SERVICE
If the fault is still present once the above checks have been undertaken or should the fault occur for a second
time, switch the machine off. Please contact your After-Sales service representative (for more information, refer
to the warranty manual).
Please, have the following details ready when calling your after-sales service representative:
• The nature of the fault.
• The dryer type and model.
• The service code (the number after the word Service on the adhesive rating plate) on the right-hand side
when the door is open.
If the dryer appears damaged or defective, unplug the appliance and contact the machine owner for contacting
our After-Sales Service.
Failure codes
Check needed by customer before Service call
Turn OFF the dryer. Unplug the dryer for more than 3 seconds.
Plug the dryer and start a new cycle with humid laundry. If the
problem persists, please call Customer Service.
Turn OFF the dryer. Unplug the dryer for more than 3 seconds.
Clean the lint filter. Check if the ambient temperature is more than
5°C. Plug the dryer. Start a new cycle with humid laundry. If the
problem persists, please call Customer Service.
Turn OFF the dryer. Unplug the dryer. Empty the bottle. Clean the
fluff filter. Plug the dryer. Start a new cycle with humid laundry. If
the problem persists, please call Customer Service.
Turn OFF the dryer. Remove the load. Start the cycle again. If the
cycle starts, the dryer was overloaded. Stop the dryer and re-load
it again with half amount of laundry. If the failure indication occurs
again, please call Customer Service.
Turn OFF the dryer. Unplug the dryer. Call the Customer Service.
Turn OFF the dryer. Turn ON the dryer and restart the same
programme as before. If the same failure occurs again, turn OFF
the dryer. Unplug the dryer. Call the Customer Service.
LED is on or blinking
5
Advertisement
