3.
Drill 2 holes with Electric Drill along the marked area in
the back side of Headlamp upper cover (C) (φ9.6mm).
(Fig 3)
Remount Meter cover (A), Headlamp cover (B),
4.
Headlamp upper cover (C) and Headlamp (D)
to the body.
5.
Install BRACKET,L ③ and BRACKET,R ④ to
Meter cover (A) and Headlamp upper cover (C), using
SPACER ⑤, SCREW (M5x16mm) ⑥, NUT ⑨ and
WASHER, RUBBER ⑩. (Fig 4)
6.
Install METER VISOR ① to BRACKET,L ③,
BRACKET,R ④ and Meter cover (A), using
SCREW (M5x20mm) ⑦, SCREW (M5x30mm) ⑧,
NUT ⑨, WASHER, RUBBER ⑩, WASHER, NYLON ⑪
and WASHER ⑫. (Fig 5)
Tightening torque
SCREW (M5x30mm) ⑧ :3Nm (2.2lbf-ft).
NOTE : Check the tightening torque of each bolt
on a regular basis and tighten as needed.
CARE
AND
MAINTENANCE
99000-9900A-04K
To clean, rinse meter visor with water to remove grit and soften dirt. Use a mild
1.
non-abrasive liquid soap, plenty of warm water, and a clean flannel cloth or soft
chamois. Rinse well to remove all soap residue. Pat dry do not wipe.
Fig 3
Fig 4
Fig 5
3 of 3
(C)
10
3
6
10
9
4
5
6
9
(C)
8
12
8
12
10
10
7
11
9
4
9
5
(A)
1
(A)
3
201503