Generac Power Systems VT HYBRID Owner's Manual page 24

9m 4x150w led
Table of Contents

Advertisement

VT HYBRID 9mt 4x150W LED
Vaihtosuuntaajan
on
Tarkista, että "On-Off-Eco"-näppäin on On-
asennossa.
Punainen
ja
vihreä
seuraavista vaihtosuuntaajan häiriöistä.
LED
Vihreä palaa / Solid Green
Punainen sammunut / Red off
Vihreä sammunut / Green off
Punainen sammunut / Red off
Vihreä sammunut / Green off
Punainen vilkkuu nopeasti /
Red blinking fast
Vihreä palaa / Solid Green
Punainen palaa / Solid Red
Vihreä sammunut / Green off
Punainen palaa / Solid Red
Vihreä palaa / Solid Green
Punainen vilkkuu hitaasti /
Red blinking slow
Vihreä sammunut / Green off
Punainen vilkkuu hitaasti /
Red blinking slow
Vihreä palaa / Solid Green
Punainen vilkkuu jaksottain /
Red blinking intermittently
Vihreä sammunut / Green off
Punainen vilkkuu jaksottain /
Red blinking intermittently
Jos vaihtosuuntaajan vihreä led-merkkivalo ei
syty, tarkista, että sulake on ehyt. Jos se on
palanut, vaihda se uuteen sulakkeeseen, joka
on ominaisuuksiltaan samanlainen.
VAROITUS !!!
Vaihtosuuntaaja voi antaa virtaa vain valoille,
joten
pylvään
generaattoriyksikkö on käynnistettävä.
FIAMM battery
oltava
aina
päällä.
led-valo
ilmoittavat
___________
_ _ _ _ _ _
___________
___________
___________
___________
_
_
_
_
_
_
_
_
___________
_ _
_ _
_ _
_ _
_ _
_ _
liikuttamista
varten
The inverters have to be always turned on:
verify that the "On-Off-Eco" button is on "On"
position.
Red and green leds signal alarm or fault on
the inverter:
STATUS
Funzionamento normale
Normal operation
Inverter spento
Inverter off
Sovratensione
Overvoltage
Imminente spegnimento causa sovraccarico
Imminent shut down due to overload
Sovraccarico / Cortocircuito
Overload / Output shortcircuit
Imminente spegnimento causa sottotensione
Imminent shut down due to under voltage
Sottotensione
Under voltage
Imminente spegnimento causa
sovratermperatura
Imminent shut down due to over temperature
Sovratemperatura
Over temperature
If the green led signal of the inverter doesn't
turn on, verify that the fuse is intact. If the
fuse is broken, replace it with a proper fuse.
WARNING !!!
The inverter can supply power to the lights
only. To operate the mast, it is necessary to
run the on-board generating set.
24
TL187-01-00-00
01-07-2016

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents